PWM Valve Driver

P/N
210373A
$129.00
In stock

The high current PWM Valve Driver is a small potted module that's commonly used to drive proportional valves from an electronic joystick or potentiometers sources. It has two analog inputs to read signals from a joystick, potentiometers, or other control devices, and has two current-regulated proportional outputs supplying up to 5 Amps each for driving most proportional valves. It has configurable input to output mapping, adjustable min/max/ramp/frequency for each output, and min/max/center for the inputs. Programming can be done from an on-board set of trimpots and jumpers, or more easily using our WiFi programming interface. Another common use is as a "soft-start" card - it will take a switch input and can just simply ramp up a proportional output to prevent mechanical shock. In this configuration, the analog inputs are configured for 0–5v, normally to be interfaced with a pressure transducer, inclinometer, or similar.

-
+

Technical Info

More Information
Weight 0.900000 Height 3.00" Width 3.80"
Depth 1.50" Communication RS-232 Supply Voltage 9V to 30VDC
Analog Inputs 0 - 5V, with +5Vref onboard. Proportional Outputs 2 proportional, current regulated outputs to adjust for variation in coil resistance or input voltage. Standard Outputs 2 proportional, current regulated outputs to adjust for variation in coil resistance or input voltage.
Output Rating 3 amp nominal, 5 amp max. Housing Material Nylon 6/6 black Connector 7 wires, 18 AWG GXL in a flame retardent mesh loom.
Protection Types Urethane-potted enclosure Operating Temperature -40°C to +85°C Storage Temperature -55°C to +100°C