Handheld RANGER System

P/N

Variable

$0.00

✓ Off the Shelf System

Our handheld RANGER systems are a dead-simple, cost-effective way to retrofit a wireless remote on a manual hydraulic system.

We couple a linear actuator per valve section with a wireless receiver that drives the actuator directly in both directions, and a handheld wireless transmitter that controls the receiver. You can set without any special programming tools the position that the valve strokes to in both the slow and fast mode.

The receiver is fully epoxy potted for the ultimate in environmental and vibration resistance and offers up to a conservatively rated 300’ of range. The linear actuator is fully weatherproof as well, and offers 90# of force and a 3” throw with an internal clutch that allows your valve to spring safely back to neutral when it’s not being actively commanded.

This kit includes the following parts:

Choice of Transmitter	We offer a choice of transmitters and up to three axes of control with our handhelds. Our MACRO series (P/N: 3A3022B) is the larger of the two options with real pushbuttons and rechargeable batteries. One step down in size from the MACRO series, the MINI (P/N: 3A3024A) radio remote has over ten years of proven success in the field. Our MICRO (P/N: 3A3025B)is a budget choice with a membrane keypad and smaller size, but with all of the same performance.
VC-134 Receiver	The wireless receiver (P/N: 3A3023C), our VC-134, is fully epoxy potted for the ultimate in environmental and vibration resistance and offers up to a conservatively-rated 300’ of range.
1-3 Linear Actuators	These CAN-enabled actuators (P/N: 1A0014F) provide 90 inch-pounds of force with a 3” maximum stroke, and built in processor for precise control of hydraulic valves. They have an internal clutch to enable freewheeling back to center position when the joystick is released or power is lost as a safety feature, and are fully weather-sealed.
Linkage Kit	This kit (P/N: 1A0018A) is comprised of adjustable linkage rods and clevises for connecting the actuators to the valve handles. The steel bracket is supplied by the installer.