Wireless VFD Remote Control

P/N

3A4821C

$269.00

✓ Off the Shelf System

This simple VFD remote control adds wireless to your VFD speed control. Using a small, keyfob sized, but highly ruggedized transmitter, we give you control over direction, start/stop, and VFD speed. The VFD radio remote steps through ten speeds, latches the reverse output ON, and has a N/O output for start that is ON in start/run mode. The receiver runs off of 9 - 30VDC (and draws 26 - 34mA if you're powering the radio from the VFD supply), but you need a minimum of 12VDC to get the full 0 - 10V for the VFD speed controller. The transmitter for the wireless VFD system runs off of internal lithium batteries that recharge over micro USB, and the system provides a nominal 300' of range.

This kit is comprised of the following parts:

Wireless VFD Remote Transmitter

Five button MICRO transmitter, pre-synchronized to the receiver, including internal rechargeable lithium polymer batteries that charge over a micro USB connection.

3A4823C

Programmable VFD receiver with three outputs, one analog 0 to 10VDC for motor speed control and two on/off outputs for motor start/stop and motor forward reverse.