Wireless E-Stop Bundle

Wireless E-Stop kits done safely, smart, and affordably. With our wireless mesh system, you can have up to seven operators with wireless E-Stop buttons for the same piece of equipment in real-time.  They are designed to meet the rigorous requirements for Safety Integrity Level (SIL) 2 based on the IEC61508  standard. 

Our wireless E-Stop system starts with a receiver with two independent solid-state sourcing outputs rated for 5A each - one which is normally ON and turns OFF in an E-Stop condition. It's reset to an ON condition when the E-Stop switch is returned to neutral/safe. The second output is normally ON and turns OFF in an E-Stop condition, but requires recycling machine power after returning to a safe position to clear the output. The receiver takes 9 - 30VDC and is epoxy potted for total protection. And because the name of the game is safety - there are redundancies at both the transmitter and receiver. The transmitter uses two normally closed switches wired in series in case one fails, and the receiver uses a third output to activate the two main outputs - if it notices a short circuit, it will engage an E-Stop condition.

We then offer a choice of three different transmitters - a small pocket-clipped wireless E-Stop switch that's vertically actuated, a larger belt-worn wireless E-Stop switch that's vertically actuated, and a horizontally actuated wireless kill switch. Only one is needed to control the receiver - you can choose any, and up to seven can be synchronized to the same receiver, so that multiple operators can kill the equipment. All three are two-way radios in a mesh configuration that give you LED indication in real-time of machine status and radio link.